Trend IMC-101 Bedienungsanleitung PDF herunterladen (Seite 9)

— 5 —

Wiring Requirements

Warning

Do not disconnect modules or wires unless power has been

switched off or the area is known to be non hazardous.

The devices may only be connected to the supply voltage

shown on the type plate.

The devices are designed for operation with a safety

extra-low voltage. Thus, they may only be connected to the

supply voltage connections and to the signal contact with

the safety extra-low voltages (SELV) in compliance with

IEC950/ EN60950/ VDE0805.

Warning

Substitution of components may impair suitability for Class

I, Division 2 and Zone 2.

These devices must be supplied by a SELV source as

defined in the Low Voltage Directive 73/23/EEC and

93/68/EEC.

Warning

This equipment has been evaluated as EEx nC IIC T4

equipment under DEMKO Certificate No. 03 ATEX

0324537U. Each module is marked with

II 3G and is

suitable for use in Zone 2 Explosive Atmospheres. Devices

must be installed in a minimum IP 54 enclosure as defined

in IEC 60529 and EN 60529.

This unit is a building-in type. During installation into a

certain end equipment it shall comply with fire enclosure

request of IEC 60950/EN60950 or similar sentence.

STEP 3:

Once the screws are fixed in the wall, insert the four screw heads through the

large parts of the keyhole-shaped apertures, and then slide MOXA Industrial

Media Converter downwards, as indicated below. Tighten the four screws for

added stability.



1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Keine Kommentare

Trend IMC-101 Bedienungsanleitung Seite 9